Screen layout

Our manuals and tutorials are available online.

Previous
Home
Up
Next

NAVIGATOR: Back - Home > Adi > Services > Support > Manuals > Apas > 3Dkin :

Home

Screen layout

Up
Hotkeys
Screen layout
Operation
File extensions
Menus
Requirements
Mouse buttons

Categories

Products
Services
Site Map
Search
About us

Search

Contact us

General info

+1 949 858 4216

Sales & support

+1 858 874 2547

E-mail

Information

Sales

Support

CHECK OUT

Our manuals and tutorials are available online.

SCREEN LAYOUT

When the 3DKin module is started the following window will appear.

wpe8.jpg (36862 bytes)

In the top of the window there is a toolbar in wich it is possible to invoke several different aspects of the module.

wpe9.jpg (3421 bytes)

From left to right the purpose of the buttons are the following:

  1. Open previous stored 3DKin project

  2. Save the current 3DKin project

  3. Create a new 3DKin project/Calculation

  4. Start calculate both legs

  5. Start calculate the Left leg only

  6. Start calculate the Right leg only

  7. View the calibration cube setup

  8. View the forceplate setup

  9. View the joint center parameters setup

  10. View the help manual

 

Previous Up Next

This page was last modified on 12/13/2002 at 20:14 PST. Copyright © 1994 - 2002, all rights reserved, Ariel Dynamics Inc. Please send your comments or feedback to webmaster@arielnet.com or proceed to our feedback form. This page has been accessed 15 times since Dec 12, 2002. Our privacy policy is here.